Jump to content

Did I damage the venue's subwoofers ?


EkLiiPz

Recommended Posts

Hey there,

I basically played my first mainroom yesterday. Everything went pretty smooth ; nice transitions, good crowd, a lot of energy, etc.

My controller was plugged to a main mixer (DJM 900), and I didn't really care about it because I wasn't using it and my levels were completely fine on my S4/Traktor. However, many times throughout my set, the room had no bass. At first I thought "Okay, the SE is messing around with the subs, which is lame", but two minutes before the end of the show, I noticed the channel I was using on the 900 was redlining all the way in.

I didn't look at the master on the 900. never used an external mixer before and didn't really care about it considering I thought everything was fine on my side.

Later on, the SE told me the amp overheated. Could I have damaged the venue's gear ? As a regular customer, it's the first time I experienced such an issue, and it had to happen on my first time.

Edit : Also, the 900 routes into the SE's digital console, which means he was monitoring levels too (compressed levels if the 900 was pushed too far).

Edited by EkLiiPz
Link to comment
even tho the mixer was redlining, the room engineer should have had his channel adjusted to fix what you were doing.. you most likely didnt overheat the amps.. he did

Thanks for the answer :)

So basically, what you're telling me is that he could have avoided further issues during my set by lowering my lows ?

Link to comment

You were probably smashing the shit out of the limiter which will end up killing all the bass. Nothing the engineer can do if the level is already peaking inside the mixer. It CAN damage the gear. In other words, watch your levels and don't go red ;)

Link to comment
×
×
  • Create New...